We will be happy to put you in direct contact with a specialist planner in your region. The more information you provide in advance, the faster you will receive a realistic offer.

System price

Please note: All calculation results are based on the entries made and a large number of preset assumptions (average values) and may vary considerably if the settings are changed. Binding statements can only be made after detailed examination by experienced consultants.

Barrier areas

Blocking areas would be e.g. windows, dormers, chimneys etc.

This size directly influences the calculation of the system size. Therefore, please indicate (in m²) which areas cannot be occupied so that a value can be determined that is as accurate as possible.

Shaded areas

Roof shading is caused, for example, by trees, antennas, neighboring houses, chimneys and other obstacles. They reduce the energy yield.

Therefore, please check whether the roof is affected by shading. This information will be of decisive importance for the solar installer when planning and designing the PV system.

Set-up angle

The installation angle of flat roof or ground-mounted systems influences the performance of the photovoltaic system in many ways: By mounting the modules, the following is achieved, among other things

• an optimal angle of inclination to the sun is created,
• the back-ventilation of the modules is guaranteed and
• the self-cleaning effect of the modules through rain or snow is exploited.

For systems in northern Germany, we recommend an installation angle of 20°.

Usable area

The usable area is the area on the roof surface you entered that can be covered with solar modules. QuickPlan has already checked whether the roof surface can be better used with vertical or horizontal module arrangement.

Please note: The possibilities for aligning the modules depend on the roof conditions and the mounting system used. This must be checked by the customer before installation.

Performance Ratio

The performance ratio is a location-dependent indicator for assessing the quality of the pv-system. It results from the ratio between the optimal and the real yield and takes into account the total losses of the entire system, inter alia, through cables, meters and contacts. This indication influences the efficiency of pv systems even more than the location factors. Today´s pv systems have a PR of 0,75-0,85.

Set-up angle

The set-up angle for the mounting of flat or open area systems affects the power of the pv-system in many ways. Flat roof or open area systems have a greate influence on the power of the pv-system: Due to the mounting of the modules is, inter alia,

• an optimal angle of inclination created to the sun
• the ventilation of the modules guaranteed
• the self-cleaning effect utilized by rain or snow

For pv systems in northern germany we recommend a set-up angle of 20°.

For you as a benchmark:

For 1 kWp installed maximum power, it is required

Please note: In case of flat roofs or open area systems, only about one third of the available area can be counted as a pv-area. To avoid mutual shading, a certain distance between the rows of modules is necessary.

Annual safety margin

This value describes the assumed annual degradation of the pv-system performance (standard 0,25 %)

guaranteed feed-in remuneration

The EEG (Renewable-Energy-Act) provides operators of a solar power system a fixed feed-in renumeration over 20 years plus the year of commissioning.

(The stated value contains the security margin)

Calculation basis

Depending on the system size, different shares of the generated electricity are remunerated. Since january 2016, the limit of the system size is 100 kWp.

If the limit is exceeded, the feed-in remuneration will be reduced to 80% of the current valid remuneration rate. (§ 38 Satz 2 EEG). Pv-systems above 10 MWp do not receive feed-in remunerations.

A more detailed calculation is offered in our profitability calculation.

Feed-in tariffs

The Renewable-Energy-Act (EEG) provides a gradual reduction of the feed-in remuneration. Thus, the time of commissioning determines - apart from the system type, the system size and the share of self-consumption - The amount of remuneration for electricity fed into the grid.

Adaption of feed-in remuneration according to EEG 2017:

The feed-in remuneration applies for a period of 20 years plus the year of commissioning. The amount is determined on the basis of the pv capacity of the previous six months. If the expansion of pv systems exceed or fall below the target value defined in the act (2,5 Gigawatt per year), the monthly reduction of the remuneration rates will be adjusted automatically. The correction of the basis degression takes place on a quarterly basis.

If there is no concrete rate of degression for the chosen date of commissioning, a non-binding forecast-value based on the current market situation is expected.

Please note: The existing fixed feed-in remuneration since 01.08.2014 only exist for small pv systems. Since 2016, operators of pv systems with a power of more than 100 kWp, have to sell their solar electricity directly on the market.

A degression value is already known for this month.

Effective annual local radiation

This value describes the effective annual solar radiation at the location on the horizontal plane, in consideration of temperatur and wind influences.